#11
|
|||
|
|||
Well the DVD boot works, it is after install I get no detection of SATA devices.
How would adding something to the DVD help? Just curious really.. THANKS for the reply either way! |
#12
|
|||
|
|||
Could REALLY use some help here guys, i'm trying to add yet another chipset to the compatibility list, as well as gain a working system.
Just for the record, i tried the iPC install on an intel ICH7 based Dell yesterday, and after choosing what I KNOW to be the correct chipset driver (ich7 is easy enough) it STILL wouldn't boot from HD after. Same problem as my nforce here, waiting for root device. Now I KNOW i chose the right one, what is going on here?????? |
#13
|
|||
|
|||
http://www.insanelymac.com/forum/ind...owtopic=109645
Hmmm I KNEW the appleviaata.kext was the driver. Looks like there IS a VIA chip on an nforce b oard hara!!! |
#14
|
|||
|
|||
Still nothing. I just copied / pasted the .kext folder into /system/extensions and overwrote everything. Is that right? Followed by -x -f -v ?
Stil lwaiting for root device.. |
#15
|
|||
|
|||
UPDATE:
NOTICE TO ALL MCP68 + NfORCE630a / GeForce7025 / Shuttle SN68SG2 USERS!!!!! In order to properly detect SATA on our platform using iPC, you must use the AppleVIAATA.KEXT NOT the AppleNforceATA.KEXT I have not yet determined if applenforceata is still required for the cd drive and other IDE devices, but i'll figure that out shortly. |
#16
|
||||
|
||||
Well in my acer aspire 5520 the internal HD or DVD-CD drive is not detected either, they are SATA. I installed thru kalyway on external usb drive, install ok, boot ok (23 sec!) but still no HD or DVD-CD drive. My chipset is mcp67, my hardware report attached.
Any clue about the SATA kext I should use? |
#17
|
|||
|
|||
panic
I have the exact same chipset as you, digitizedsoul and I am using iPC 10.5.6. I have one IDE HDD and one IDE DVD burner. I cannot get this to work. Right after the install I get this message:
panic(cpu 0 caller 0x001A429B): Unresolved kernel trap (CPU 0, Type 14=page fault), registers: CR0: 0x8001003b, CR2: 0x000000fb, CR3: 0x01123000, CR4: 0x000006e0 EAX: 0x0bfdcbb4, EBX: 0x0bfdcb80, ECX: 0xffffffff, EDX: 0x0c12a800 CR2: 0x000000fb, EBP: 0x48353df8, ESI: 0x0971ab00, EDI: 0x0bfdcbb4 EFL: 0x00010206, EIP: 0x00592be9, CS: 0x00000008, DS: 0x0b490010 I also get a lot of the IOUSBOHCI OHCI controller will be unloaded messages. What am I doing wrong? Any help will be greatly appreciated 💡 Deploy cloud instances seamlessly on DigitalOcean. Free credits ($100) for InfMac readers. |